Requirements 153 – Konica Minolta Magicolor 3300DN User Manual
Page 161
Requirements
153
In a place with the following characteristics:
In a place away from the following:
Do not tilt the printer more than 10° when moving it.
If the printer is located in a cold room that is rapidly heated, or if the printer
is moved from a cold place to a warm, humid place, condensation may
occur within the printer, degrading print quality. If this occurs, allow the
printer to adapt to the environment for about one hour before use.
Media
5.2 lbs (1.9 kg) per ream of 20 lb
bond (75 g/m
2
) paper
1x500 High-capacity input feeder
(HCIF)
32.0 lbs (14.5 kg)
(with packaging)
2x500 High-capacity input feeder
(HCIF)
49.6 lbs (22.5 kg)
(with packaging)
On a hard, flat, stable, level (±5° or less slant at any point on the
machine) surface. A surface can be tested for levelness with a standard
round pencil. If the pencil rolls, the surface is not level.
Close to an easily accessible grounded power supply (on an exclusively
dedicated power outlet) that meets printer specifications.
Near your computer—at the length 6.5'/2 m or less for an IEEE 1284
bidirectional parallel connection.
With enough space to allow adequate ventilation and easy servicing.
With an ambient temperature range of 50°–90° F/10°–32° C and relative
humidity range of 15%–85% (noncondensating).
At an altitude of 0–10,170'/0–3,100 m.
Direct sunlight, heating and cooling sources, extreme temperature and
humidity changes, wind, dust, open flames, and items that can easily
burn.
A connection to the same electrical circuit as high-current machines,
noise-generating equipment (such as a copier or air conditioner), and
strong magnetic or electromagnetic fields (such as a refrigerator).
Water, water pipes, liquid (drink) containers, and corrosive chemicals or
vapors, such as ammonia.
Small, loose metal parts, such as paper clips and staples.
Component
Weight