Konica Minolta BIZHUB C652DS - Manual (Page 44)

bizhub C652/C652DS/C552/C552DS/C452 5-6
5.1 Windows Vista/Server 2008 5
In Windows Server 2008:
"Add Printer" Wizard appears.
5
Click "Add a local printer".
The page for selecting a printer port appears.
6
Click "Create a new port", and then select the port type.
% To use the LPR/Port 9100 protocol, select "Standard TCP/IP Port".
% To use the SMB connection, select "Local Port".
7
Click [Next].
8
Specify the IP address and port.
% To use the LPR/Port 9100 protocol, select "TCP/IP Device", and then enter the IP address.
% To use the SMB connection, enter "\\NetBIOS name\print service name" in the "Port Name" box.
% Enter the same NetBIOS name and print service name specified in "Print Setting" in "SMB Setting".
9
Click [Next].
% If the "Additional Port Information Required" page appears, go to Step 10.
% If the "Install the printer driver" page appears, go to Step 13.
10
Select "Custom", and then click [Settings].
11
Change the settings according to the port, and then click [OK].
% For LPR connection, select "LPR", and then enter "Print" in the "Queue name" box.
% You must discriminate between upper and lower case letters when entering it.
% For Port 9100, select "Raw", and then enter a RAW port number (initial setting: "9100") in the "Port
Number" box.
% If both LPR and Port 9100 are enabled on the printer, the printer driver is connected to the machine
using LPR.
12
Click [Next].
The "Install the printer driver" page appears.