Panasonic -eng - Manual (Page 80)

Edit mode
- 80 -
Non-linear edit mode
∫ Audio Mix setting screen
You can make detailed settings in the Audio Mix
settings screen.
A. The names of audio files and their locations are
displayed.
B. You can set the volumes for the original audio and
the added audio (SBG or WAV file)
by moving the slider.
[BGM]
You can adjust the volume for the added audio.
[Edit track]
You can adjust the volume for the original audio.
• In the initial setting, both are set to 100%.
• Move it to the right for higher volume levels or to the
left for lower volume levels.
If both [BGM] and [Edit track] are set to 0%, no
audio will be played.
C. You can set the applicable range of the audio added.
Drag / to set the times for the start point and
the end point. (The section to be used is displayed in
orange.)
• In the initial setting, the start point is set to 0 and the
end point is set so that the audio is applied only to
the added clip.
You can extend the range to set the audio over to
the subsequent clip.
• You can also set it by clicking in the start point
and end point boxes.
• In the duration box, you can set the duration
between the start point and the end point.
• The duration of the background music file and that
between the start point and the end point may not
coincide. This is due to only the display and does
not affect the processing.
D. Check, and the start point and the end point will be
interlocked.
It is convenient if you want to keep the length of the
audio file.
E. You can check the settings on video
• You can also check the setting by moving the slider.
E
A
B
F
C
D