ADC CUDA 3 - Manual (Page 573)

Cuda 12000 IP Access Switch CLI-based Administration Guide
OSPF Commands 571
ospf area
[authentication {md5 | password}]
[[stub [no-summary]] [default-cost
] [range
[advertise-matching]] [{enable |
disable}] router:ospf Creates an OSPF area which you
can then apply to select interfaces
using the ip ospf area-id command
within interface::csi mode.
ospf-vi
router:ospf Configures the transit area and the
router ID of the neighbor for a
virtual interface.
ospf-vi
authentication
{md5 | password} router:ospf Configures the authentication type
for a virtual interface.
ospf-vi
authentication
{key-id key | key } router:ospf Configures the authentication key
for a virtual interface.
ospf-vi
dead-interval
router:ospf Configures the dead-interval for a
virtual interface.
ospf-vi
hello-interval
router:ospf Configures the Hello interval for a
virtual interface.
ospf-vi
retransmit-interval
router:ospf Configures the retransmit interval
for a virtual interface.
ospf-vi
transit-delay
router:ospf Configures the transit delay for a
virtual interface.
report {ospf-nbr-state |
ospf-virt-nbr-state} router:ospf Enables sending of OSPF neighbor
state trap and OSPF virtual
neighbor state trap.
router ospf Any Enters OSPF global configuration
mode.
router-id router:ospf Configures the OSPF router ID for
this system. The router ID applies
to all OSPF interfaces; a single
source router ID.
Command Mode Description