ADC CUDA 3 - Manual (Page 317)

Cuda 12000 IP Access Switch CLI-based Administration Guide
Configuring OSPF 315
Use this procedure to configure a virtual interface:
Task Command
1. Enter router-ospf mode. router ospf
2. Configure the transit area and the
router ID of the neighbor for this
virtual interface.
ospf-vi
3. Configure the dead-interval, in
seconds.
OSPF neighbors connected by a
virtual interface must have matching
dead interval values in their respective
virtual interface configurations.
ospf-vi
dead-interval
4. Configure the Hello interval, in
seconds, in seconds.
OSPF neighbors connected by a
virtual interface must have matching
hello interval values in their respective
virtual interface configurations.
ospf-vi
hello-interval
5. Configure the retransmit interval, in
seconds.
While it is common practice to
configure OSPF neighbors connected
by a virtual interface with matching
retransmit interval values, it is not
required.
ospf-vi
retransmit-interval
6. Configure the transit-delay, in
seconds.
While it is common practice to
configure OSPF neighbors connected
by a virtual interface with matching
transit delay values, it is not required.
ospf-vi
transit-delay