ADC CUDA 3 - Manual (Page 260)

ADC Telecommunications, Inc.
258 C HAPTER 12: C ONFIGURING DHCP R ELAY
Configuring Default Policies
To modify the default DHCP or BOOTP policy used on all interfaces of a
specific DOCSIS module, enter interface cable mode for one of the
interfaces on the selected DOCSIS module and perform the following task:
To display the currently configured default DHCP or BOOTP policy, enter
interface cable mode for one of the interfaces on the selected
DOCSIS module and perform the following tasks:
Note that you cannot delete the default DHCP or BOOTP policy.
Task Command
1. Modify the default DHCP policy.
Note that you do not define
matching criteria for the default
policy. You simply configure it to
permit forwarding to up to 32
DHCP servers, or drop the packet.
dhcp-policy default
{permit ... | deny}
2. Modify the default BOOTP policy.
Note that you do not define
matching criteria for the default
policy. You simply configure it to
permit forwarding to BOOTP
servers, or drop the message.
bootp-policy default
{permit ... | deny}
Task Command
1. Display the default DHCP policy. show dhcp-policy default
2. Display the default BOOTP policy. show bootp-policy default