ADC CUDA 3 - Manual (Page 124)

ADC Telecommunications, Inc.
122 C HAPTER 7: P ACKET O VER SONET A DMINISTRATION
Rx Abort The number of packets received on this
link in which the abort sequence is
detected.
Rx Runts The number of packets received on this
link which are smaller than the minimum
packet size.
Interface Type Displays “ppp” (Point-to-Point Protocol).
Interface Speed Transmission speed in Kbits.
Interface in Unicast Pkts Number of Unicast packets received on
this interface.
Interface in Discards Total number of incoming packets that
were discarded by this interface.
Interface in Errors Number of incoming packet errors seen
on this interface.
Interface Out Unicast Pkts Number of Unicast packets transmitted
from this interface.
Interface Out Discards Total number of outgoing packets that
were discarded by this interface.
Interface Out Errors Number of outgoing packet errors seen
on this interface.
LCP Indicates whether the LCP layer is open or
closed on this interface.
Open Indicates which network layer protocols
are open. For example IPCP would be
displayed when IP is up.
Negotiation Attempts The maximum number of link negotiation
attempts allowed by this interface.
Retry Timeout Interval to wait between link connection
retries.
IPCP IP Address Report Indicates whether NCP is enabled for the
transmission of IP datagrams. IP Control
Protocol (IPCP) is the network control
protocol used.
Line Type Indicates SONET line type.
Clock Source Indicates the clock source configured for
this interface.
Path Signal Id - C2 byte C2 byte received in last packet.
Packet Scrambling Indicates whether packet scrambling in
enabled or disabled.
Display Element Description