ADC CUDA 3 - Manual (Page 270)

ADC Telecommunications, Inc.
268 C HAPTER 13: C ONFIGURING DHCP A UTHORITY
Removing DHCP Authority Ranges
You can remove DHCP Authority ranges using the no dhcp-authority
command. You may want to do so if you no longer require the range, or if
you want to redefine the range. Note that you cannot modify DHCP
Authority ranges, so if you want to redefine a range, you must delete it and
then recreate it with the new configuration.
To remove a DHCP authority range from an interface, perform the following
task within interface configuration mode:
Example
The following example removes DHCP authority range 1 from interface
1/1/1:
cli:192.168.208.3:root# interface 1/1/1
mode: interface:cable:csi(1/1/1)
cli:192.168.208.3:interface:cable:csi(1/1/1)# show dhcp-authority
row count: 1
Range Number Lower Range Upper Range Status
---------------- ---------------- ---------------- ------
1 172.16.19.10 172.16.19.20 1
DHCP Authority Status enable
cli:192.168.208.3:interface:cable:csi(1/1/1)# no dhcp-authority 1
cli:192.168.208.3:interface:cable:csi(1/1/1)# show dhcp-authority
Range Number Lower Range Upper Range Status
---------------- ---------------- ---------------- ------
DHCP Authority Status enable
Task Command
1. Enter interface configuration
mode.
interface
2. Remove a DHCP authority range
from the current interface.
no dhcp-authority