ADC CUDA 3 - Manual (Page 399)

Cuda 12000 IP Access Switch CLI-based Administration Guide
Configuring Upstream Channels 397
Range-Backoff
The Range Backoff Start parameter sets the fixed start value for range
backoff on the upstream channels. By default the start value is set to 2 and
the end value is set to 10. Acceptable values are 0 to 15.
You set ranging backoff values on the upstream channel by performing the
following task.
.
Task Command
1. Enter interface cable mode. interface cable
2. Configure the ranging backoff for
an upstream channel.
upstream
range-backoff