ADC CUDA 3 - Manual (Page 567)

Cuda 12000 IP Access Switch CLI-based Administration Guide
IP Administration and Route Filtering Commands 565
IP Administration and Route Filtering Commands
Table A-4 IP Administration and Route Filtering Commands
Command Mode Description
access-class {in | out}
priority interface:cable:csi Applies filtering rules (access-lists)
to interfaces.
access-list {deny |
permit} ip {address> | host address> | any } {address> |
host | any}
[tos ] [change-tos
]
■
root
■
interface:cable:csi
A sequential set of filtering rules to
which inbound and outbound
packets can be applied.
add arp
interface::csi Adds an ARP (Address Resolution
Protocol) entry to the ARP cache
on a selected interface.
arp timeout interface::csi Sets the timeout for dynamic ARP
cache entries.
clear arp-cache
■
root
■
interface::csi
Deletes all non-static ARP entries.
clear ip igmp group
[]
■
root
■
interface::csi
Deletes multicast group entries.
del arp interface::csi Removes an ARP (Address
Resolution Protocol) entry from the
ARP cache on a selected interface.
dhcp-authority {enable | disable} interface::csi Enables and configures DHCP
authority ranges on the current
interface. DHCP authority secures
all IP addresses Any address that
falls within the range are labelled
as DHCP within the ARP table
upon acknowledgement from the
host. This tagging of the ARP
cache entry ensures that another
MAC host cannot use the IP
address.
export
■
router:rip
■
router:ospf
Enters export mode. From within
this mode you can create export
Routing Information Protocol (RIP)
or Open Shortest Path First (OSPF)
route filters.