ADC CUDA 3 - Manual (Page 299)

Cuda 12000 IP Access Switch CLI-based Administration Guide
Configuring RIP 297
Disabling RIP on IP Interfaces
Use this procedure to disable RIP on an interface:
For more information on these commands, refer to the Cuda 12000 IP
Access Switch CLI Reference Guide.
Removing RIP from IP Interfaces
You remove RIP from an interface by performing the following tasks:
Task Command
1. Enter configuration mode for the
interface for which you want to
disable RIP.
interface
2. Enter the IP address of this
interface.
ip address
3. Disable RIP on the interface. ip rip disable
Task Command
1. Enter configuration mode for the
interface from which you want to
remove RIP.
interface
2. Enter the IP address of this
interface.
ip address
3. Remove RIP from the interface. no ip rip