Samsung SGH-T699DABTMB - Manual (Page 249)

Changing Your Settings 243
5. Complete the transfer process between the two
NFC-enabled devices by placing them back to back.
This feature can come in very handy to quickly share
pictures between users with compatible S Beam devices. For
more information, refer to “Using S Beam to Share Pictures”
on page 150.
Wi-Fi Direct Setup and Settings
You can configure your device to connect directly with other
Wi-Fi capable devices. This is an easy way to transfer data
between devices. These devices must be enabled for Wi-Fi
direct communication. This connection is direct and not via a
HotSpot or WAP.
Note: Activating this feature will disconnect your current Wi-Fi
network connection.
To give your Wi-Fi Direct connection a unique name:
It can be difficult to pair to external devices if all you have is
a generic name (ex: Android 12345). It is recommended you
provide your connection with a unique name.
1. Press ➔ and then tap Settings ➔
More settings ➔ Wi-Fi Direct.
2. Press then tap Device name.
3. Edit the current name and tap OK to save the new
identification.
To activate your connection:
1. Press ➔ and then tap Settings ➔
More settings.
2. In a single motion touch and slide the Wi-Fi Direct slider
to the right to turn it on . The
slider color indicates the activation status.
3. Read the on-screen information and tap OK.
4. Tap Scan and select the single device name to begin
the connection process to another Wi-Fi Direct
compatible device.
– or –
Tap Multi-connect ➔ Scan and select all the device
names to begin the connection process to these Wi-Fi
Direct compatible devices.
Note: The target device must also have Wi-Fi Direct service
active and running before it can be detected by your
device.
5. Tap Done. The direct connection is then established.
OFF ON