Horner APG XL7 OCS User Manual
Xl7 ocs, User manual for
Table of contents
Document Outline
- PREFACE
- Table of Contents
- INTENTIONALLY LEFT BLANK
- CHAPTER 1: safety / compliance
- CHAPTER 2: introduction
- XL7 OCS
- CHAPTER 3: Mechanical installation
- 3.1 Overview
- 3.2 Mounting Requirements
- 3.2.1 Mounting Procedures (Installed in a Panel Door)
- 3.4 Panel Cut-Out
- 3.5 XL7 Dimensions
- 3.6.1 Clearance / Adequate Space
- 3.6.2 Grounding
- 3.6.3 Temperature / Ventilation
- 3.6.5 Noise
- Consider the impact on the panel layout design and clearance requirements if noise suppression devices are needed. Be sure to maintain an adequate distance between the XL7 OCS and noisy devices such as relays, motor starters, etc.
- 3.6.6 Shock and Vibration
- 3.6.7 Panel Layout Design and Clearance Checklist
- CHAPTER 4: ELECTRICAL INSTALLATION
- CHAPTER 5: SERIAL COMMUNICATIONS
- CHAPTER 6: CAN Communications
- CHAPTER 7: Ethernet Communication
- CHAPTER 8: Communication options
- CHAPTER 9: REMOVABLE MEDIA
- 9.1 Overview
- 9.2 MicroSD Cards
- 9.3 MicroSD File System
- 9.4 Using the Removable Media Manager
- 9.5 Using Removable Media to Log Data
- 9.7 Using Removable Media to View and Capture Screens
- 9.8 Removable Media (RM) Function Blocks in Cscape
- 9.9 Filenames used with the Removable Media (RM) Function Blocks
- 9.10 System Registers used with RM
- CHAPTER 10: GENERAL I/O
- CHAPTER 11: HIGH SPEED I/O (HSC / PWM)
- 11.1 Overview
- 11.3.1 Frequency
- 11.3.2 Totalize
- 11.3.3 Pulse Width Measurement
- Figures 11.1-11.2 - Pulse Width Measurements, High & Low
- 11.3.4 Period Measurement
- Figures 11.3-11.4 – Period Measurement, Rising Edges & Falling Edges
- 11.3.5 Quadrature
- Figures 11.5 – Quadrature
- 11.5.1 Normal
- 11.5.2 PWM
- 11.5.3 HSC Output (High Speed Counter Match)
- 11.5.4 Stepper Function
- 11.6 PWM Functions Register Map
- 11.8 STP Examples
- 11.1 Overview
- CHAPTER 12: SYSTEM SETTINGS AND ADJUSTMENTS
- 12.1 System Menu - Overview
- 12.2 System Menu – Navigation and Editing
- 12.4 Touch screen calibration
- The touch screen is calibrated at the factory and rarely needs modification. However, if actual touch locations do not appear to correspond with responding objects on the display, field adjustment is available. To access the field adjustable touch s...
- CHAPTER 13: USER INTERFACE
- CHAPTER 15: CSCAPE CONFIGURATION
- CHAPTER 17: Clone Unit
- CHAPTER 18: Maintenance
- CHAPTER 19: troubleshooting / technical support