AMD Geode SC2200 - Manual (Page 351)

AMD Geode™ SC2200 Processor Data Book 369
9
Electrical Specifications 32580B
9.0
Electrical Specifications
This chapter provides information about:
• General electrical specifications.
• DC characteristics.
• AC characteristics.
• All voltage values in this chapter are with respect to V
SS
unless otherwise noted.
9.1 General Specifications
9.1.1 Electro Static Discharge (ESD)
This device is a high performance integrated circuit and is
ESD sensitive. Handling and assembly of this device
should be performed at ESD free workstations. Table 9-1
lists the ESD ratings of the SC2200.
9.1.2 Power/Ground Connections and
Decoupling
When testing and operating the SC2200, use standard
high frequency techniques to reduce parasitic effects. For
example:
• Filter the DC power leads with low-inductance decou-
pling capacitors.
• Use low-impedance wiring.
• Utilizing the PWR and GND pins.
9.1.3 Absolute Maximum Ratings
Stresses beyond those indicated in the Table 9-2 on page
369 may cause permanent damage to the SC2200, reduce
device reliability, and result in premature failure, even when
there is no immediately apparent sign of failure. Prolonged
exposure to conditions at or near the absolute maximum
ratings may also result in reduced device life span and
reduced reliability.
Note: The values in the following table are stress ratings
only. They do not imply that operation under other
conditions is impossible.
Table 9-1. Electro Static Discharge (ESD)
Parameter Units
Human Body Model (HBM) 2000V ESD
Machine Model (MM) 200V ESD
Table 9-2. Absolute Maximum Ratings
Symbol Parameter Min Max Unit Comments
T
CASE
Operating case temperature -10 110 o C Note 1
T
STORAGE
Storage temperature -45 125 o C
Note 2
V
CC
Supply voltage See Table
9-3
V
V
MAX
Voltage on
5V tolerant balls -0.5 6.0 V Note 3
Others -0.5 3.6 V Note 3, Note 4
I
IK
Input clamp current -0.5 10 mA Note 1
I
OK
Output clamp current 25 mA Note 1
Note 1. Power applied - no clocks.
Note 2. No bias.
Note 3. Voltage min is -0.8V with a transient voltage of 20 ns or less.
Note 4. Voltage max is 4.0V with a transient voltage of 20 ns or less.