Adding back-end lus to stripe sets – HP SAN Virtualization Services Platform User Manual
Page 78
6.
Click Next. The Select Back-End LU(s) screen appears.
Figure 11 Create Stripe Set wizard—Select Back-End LU(s) screen
7.
Select a back-end LU that you want to add to the stripe set. Back-end LUs that are already
configured, absent, or not accessible are not selectable.
8.
Click Add. The selected back-end LU is added to the list in the lower area of the screen.
9.
Repeat steps 7 and 8 until the lower list displays all the back-end LUs that you want to include
in the stripe set. To remove a back-end LU from the lower list at any time, select the back-end LU
and click Remove.
10.
Click Next. The Select folder screen appears.
11.
If you want to add the stripe set to a folder, enter the folder name in the Folder field or click
Browse to browse to the folder. The folder must already be created. For information about creating
folders, see “
12.
Click Next. A confirmation screen appears.
13.
Click Finish. The new stripe set is created and is displayed in the Stripe Sets list.
Adding back-end LUs to stripe sets
You can add a back-end LU to a stripe set only if:
•
No virtual disk is currently mapped to the stripe set.
and
•
The back-end LU is not currently configured as a member of any stripe set or storage pool.
There are two ways to add back-end LUs to stripe sets:
•
Adding a back-end LU to a stripe set by selecting the back-end LU
•
Adding back-end LUs to a stripe set by selecting the stripe set
Adding a back-end LU to a stripe set by selecting the back-end LU
To add a back-end LU to a stripe set by selecting the back-end LU:
Working with stripe sets
78