HP XP P9500 Storage User Manual
Page 79
Table 20 Copy pair statuses of volumes obtained by the YKQRYDEV command (Cnt Ac-J Z)
Description
Status of the copy pair in the
storage system
Copy pair status acquired by
YKQRYDEV
SIMPLEX
status.
Simplex
SIMPLEX
The copy pair is changing to the DUPLEX status (during
an initial copy or resynchronization).
Duplex Pending
PENDING (01)
DUPLEX
status.
Duplex
DUPLEX (02)
The user has suspended the copy pair from the P-VOL.
Suspended
SUSPOP (03)
The user has suspended the S-VOL. (The P-VOL has been
updated and the differential data between the P-VOL and
S-VOL is being recorded.)
Suspended
SUSPOP (04)
The user has suspended a copy pair for which REVERSE
is specified.
Suspended
SWAPPING (04)
The copy pair has been suspended because the secondary
storage system has received a suspend request from the
primary storage system.
Suspended
SUSPOP (05)
The copy pair has been suspended because the primary
storage system has detected an error status on the
secondary storage system.
Suspended
SUSPCU (06)
The P-VOL has been suspended because the user dissolved
the copy pair from the S-VOL (changed to the SIMPLEX
status).
Suspended
SUSPER (07)
The copy pair has been suspended because the primary
storage system detected either an error during migration
Suspended
SUSPCU (08)
with the secondary storage system or an I/O error during
update copying.
The copy pair has been suspended because the primary
storage system detected that the pair control information
Suspended
SUSPER (09)
stored in memory was lost when the power was turned on
(IMPL). This error occurs when the primary storage system
is turned off after the backup time for non-volatile memory
has been exceeded.
The copy pair has been suspended because the data
between the P-VOL data and the S-VOL data did not match
Suspended
SUSPER (50)
during the initial copying phase. Invalid track formatting
causes this error.
The copy pair is changing to the suspend status.
Suspending
TRANS (60)
The copy pair is changing to the Simplex status.
Deleting
TRANS (61)
The primary storage system has suspended all the copy
pairs due to a planned outage (turned off).
Suspended
SUSPER (62)
Copy pairs are ready to perform a Delta Resync, and a
Delta Resync can be performed.
HOLD
HOLD (70)
A transition to HOLDER status indicates that the differential
data cannot be kept in a journal due to a hardware failure
HOLDER
HOLDER (71)
such as a cache memory, shared memory, or journal
volume failure.
The status of a Delta Resync pair is being changed to the
HOLD
status.
HOLDTRNS
HOLDTRNS (72)
The user tried to perform a Delta Resync, but the copy pair
changed to the HOLDER status because the copy pair is
HOLDER
HOLDER (73)
Understanding copy group operations
79