HP XP P9500 Storage - Manual (Page 638)

Starting a Business Continuity Manager agent
To start a Business Continuity Manager agent, use the START command.
Business Continuity Manager agents reside on the system, and run in accordance with the definition
of the YKPRMxx initialization parameter. You can start multiple Business Continuity Manager
agents.
Because Business Continuity Manager uses the TCP/IP protocol to communicate with HP Command
View Advanced Edition products, always start the IBM Communications Server before starting
Business Continuity Manager. If you do not start them in this order, the YKY315I message displays
and startup fails.
Format
START
Δ
1
cataloged-procedure-for-startup-name[.identification-name]
[,MEMBER=member-name]
[,SYSOUT=output-class]
Operands
cataloged-procedure-for-startup-name
Used to specify the name of the cataloged procedure for startup of the Business Continuity Manager
agent you are going to start.
identification-name
Used to specify an identification name of the catalogued procedure for startup. This operand
identifies each job when the same startup cataloged procedure name is used to start multiple jobs.
MEMBER =member-name
Used to specify a member name of the initialization parameter.
If omitted, the standard member name specified in the cataloged procedure for startup is used.
SYSOUT =output-class
Used to specify an output class for the output list. If omitted, the output class is automatically
determined based on the system settings.
Example
To start a Business Continuity Manager agent with the following conditions, enter the command
shown below.
•
Name of the cataloged procedure: YKAGENT
•
Identifier: YK
•
Member name of the initialization parameter: YKPRM10
•
Output class: X
START YKAGENT.YK,MEMBER=YKPRM10,SYSOUT=X
Stopping a Business Continuity Manager agent
To stop a Business Continuity Manager agent, use the STOP command.
If a request from another HP Command View Advanced Edition product has already been accepted
before the STOP command was executed, the stop processing will be suspended until the processing
for that request is completed.
Format
If both the name of the cataloged procedure for startup and the identification name were specified
in the START command:
638 Linkage with Replication Manager