7 using business continuity manager, Before using copy pairs, Preparing to use the remote dkc control function – HP XP P9500 Storage User Manual
Page 290: When executing copy group operation commands
7 Using Business Continuity Manager
This chapter explains how to use Business Continuity Manager functionality.
Before using copy pairs
This section explains what you should be aware of and do before you use copy pairs.
Preparing to Use the Remote DKC Control Function
The following need to be prepared before the Remote DKC Control Function is used:
1.
Place command devices offline.
Before using the Remote DKC Control Function, all command devices should be placed offline.
2.
Execute the YKLOAD command from the ISPF panel or script, with the DAD parameter and
ROUTE
parameter specified. However, in the ISPF panel, you can omit the ROUTE parameter
specification in the YKLOAD command execution if Y and Preset RouteListID are specified for
Remote DKC Function of the Set Defaults panel.
NOTE:
•
A volume defined as a command device cannot be defined as a volume for a copy group
simultaneously. If the command device is defined as a volume in a copy group by mistake,
when the corresponding copy group is used, it results in an I/O error.
•
When a command device fails, prepare new volumes for the Primary storage system and the
Secondary storage system, recreate the route list with a new APID, and register the list in the
storage system again.
•
Do not delete paths (inter-control unit logical paths or inter-disk controller logical paths) among
storage systems when a command device is defined.
•
The YKBLDCMD command must be re-executed after the storage system is turned off.
When Executing Copy Group Operation Commands
You can specify the SELECT parameter for a command that changes the status of a copy pair.
When SELECT(ALL) is specified, copy pairs of all statuses are subject to operation, and when
SELECT(COND)
is specified, copy pairs with statuses for which command execution is possible
are subject to operation.
lists the copy pair statuses for which commands with SELECT(COND) specified
can be executed. When SELECT(COND) is specified, whether the command can be executed is
determined by using the copy pair status that was obtained when the YKQUERY or YKEWAIT
command was most recently executed. Commands other than those shown in
are executed regardless of volume status.
Table 96 Copy Pair Statuses for Commands with SELECT(COND) Specified Are Subject to Processing
Copy pair status
Command
name
INV
CON
NDL
HTR
HER
HLD
REV
SWP
SVS
TRN
SER
SCU
SOP
PND
DUP
SMP
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
Yes
YKMAKE
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
Yes
YKMAKE
HOLD
No
No
No
No
No
No
No
Yes
Yes
No
Yes
Yes
Yes
No
No
No
YKRESYNC
No
No
No
No
No
Yes
No
No
No
No
No
No
No
No
No
No
YKRESYNC
DELTAJNL
290 Using Business Continuity Manager