HP XP P9500 Storage - Manual (Page 615)

Table 110 List of functions of BCM Monitor commands (continued)
Function Command Name
Puts BCM Monitor to sleep SLEEP
Wakes up BCM Monitor WAKEUP
For the symbols used in the explanation on the format of operator commands, see “Conventions
in syntax explanations” (page 683) .
NOTE:
•
If it takes a long time to perform an action, there will be a long delay before the operator
command is executed.
•
BCM Monitor can only accept a maximum of 10 operator commands. Therefore, do not
execute more than 10 operator commands in a row.
•
BCM Monitor can retain a maximum of 50 commands waiting to be executed. However, if
the number of commands waiting to be executed exceeds 50, an error occurs.
DISPLAY command
To display the status of BCM Monitor, use the MODIFY DISPLAY command. This command allows
you to display the following information.
•
Values that are currently effective for the parameters specified in the YKMONOPT file
•
Values that are currently effective for the parameters specified in the YKMONCG file
•
Commands waiting to be executed
Format
If both the name of the cataloged procedure for startup and the identification name were specified
in the START command:
MODIFY
Δ
1
cataloged-procedure-for-startup-name.]identification-name
,DISPLAY
Δ
1
{OPTIONS|CGDEF|OPCMDS}
If only the name of the cataloged procedure for startup was specified in the START command.
MODIFY
Δ
1
cataloged-procedure-for-startup-name
,DISPLAY
Δ
1
{OPTIONS|CGDEF|OPCMDS}
Operands
cataloged-procedure-for-startup-name
Used to specify the name of the cataloged procedure for startup that was specified in the START
command when BCM Monitor was started.
identification-name
Used to specify the identification name that was specified in the START command when BCM
Monitor was started.
DISPLAY
Used to display the status of BCM Monitor. If values specified in the BCM Monitor parameter files
are changed after BCM Monitor has started, the values that are in effect at that moment are
displayed. Even if you change the values after BCM Monitor has started, the values specified in
the BCM Monitor parameter files are not changed. The information to be displayed is specified
by the following sub-operands:
Operator commands available in BCM Monitor 615