HP XP P9500 Storage - Manual (Page 78)

Table 19 Copy pair statuses of volumes obtained by the YKQRYDEV command (Cnt Ac-S Z or TCA)
Description Status of the copy pair in the
storage system
Copy pair status acquired by
YKQRYDEV
SIMPLEX status. Simplex SIMPLEX
The copy pair is changing to the DUPLEX status (during
an initial copy or resynchronization). Duplex Pending PENDING (01)
DUPLEX status. Duplex DUPLEX (02)
The host has suspended the P-VOL. Suspended SUSPOP (03)
The user has suspended the S-VOL. (The P-VOL has been
updated and the differential data between the P-VOL and
S-VOL is being recorded.) Suspended SUSPOP (04)
The user has suspended a copy pair in which REVERSE is
specified. Suspended SWAPPING (04)
The copy pair has been suspended because the secondary
storage system has received a suspend request from the
primary storage system. Suspended SUSPOP (05)
The copy pair has been suspended because the PPRC
FREEZE
command is issued to the primary storage system.
Suspended SUSPOP (0A)
The copy pair has been suspended because the primary
storage system has detected an error status on the
secondary storage system. Suspended SUSPCU (06)
The P-VOL has been suspended because the user dissolved
the copy pair from the S-VOL (changed to the SIMPLEX
status). Suspended SUSPER (07)
The copy pair has been suspended because the primary
storage system detected either an error during migration Suspended SUSPCU (08)
with the secondary storage system or an I/O error during
update copying.
The copy pair has been suspended because the primary
storage system detected that the pair control information Suspended SUSPER (09)
stored in memory was volatile when the power was turned
on (IMPL). This error occurs when the primary storage
system is turned off after the backup time for non-volatile
memory has been exceeded.
The copy pair has been suspended because the data
between the P-VOL data and the S-VOL data did not match Suspended SUSPER (50)
during the initial copying phase. Invalid track formatting
causes this error.
The copy pair is changing to the suspend status. Suspending TRANS (60)
The copy pair is changing to the SIMPLEX status. Deleting TRANS (61)
The primary storage system has suspended all the copy
pairs due to a planned outage (turned off). Suspended SUSPER (62)
An update I/O without a timestamp was detected on a
pair in a consistency group for which SYSTEM is set as the
timer type. SEQCHK SUSPER (A0)
78 Business Continuity Manager with replication products