Brother PE-DESIGN Ver.6 - Manual (Page 72)

64
Creating Large-Size Embroidery Patterns
b
Memo:
• The templates are included in the
package.
• The templates are also in the Template
folder and can be printed out with a printer.
1. Punch a hole at the end of each arrow on the
template.
2.
Place the template on the fabric, and then
insert the tip of a marking pen into each hole
to mark the fabric.
3. Connect the points marked on the fabric to
draw reference lines.
For a large embroidery pattern, reposition the
template to draw the embroidering position for each
section of the embroidery pattern.
1.
Place the template on the fabric, and mark
points A, B, C and D.
2.
To mark an area to the right of the previously
marked area, align points A and D on the
template with marks B and C on the fabric.
To mark an area below the previously marked
area, align points A and B on the template with
marks C and D on the fabric.
A B
D C
a
Note:
• The intersection of the horizontal and
vertical line indicates the center of the
embroidery hoop.
• While carefully considering how the fabric
will be hooped, place the template on the
fabric, and then draw lines to indicate the
embroidering position. In addition, because
all embroidery areas are not drawn on the
template for large embroidery hoops, be
careful that the embroidery area does not
extend from the marked area on the fabric as
shown below.
A B
D C
A B
D C
A B
D C
A B
D C
PeDesignV6Eng.book Page 64 Thursday, July 8, 2004 11:59 AM