Brother PE-DESIGN Ver.6 - Manual (Page 18)

10
Before Use
[STEP 2] Installing the driver for the card writer module
This section describes how to install the driver for the card writer module.
1.
Plug the USB connector into the USB port on
the computer.
Make sure that the connector is fully inserted.
For Windows XP users connected to the
Internet:
→ The installation of the driver is completed
automatically.
For all other users:
→ After a short while, the Found New Hard-
ware Wizard (or Add New Hardware
Wizard) dialog box appears.
2. For Windows XP: Select Install from a list or
specific location [Advanced], and then click
Next.
Select Search removable media (floppy,
CD-ROM...), and then click Next.
For Windows 98: Select Search for the best
driver for your device. (Recommended),
and then click Next.
Select CD-ROM drive, and then click Next.
a
Note:
If you upgrading from version 5.02 or later, skip this section and continue with the procedure described in
“[STEP 3] Upgrading the USB card writer module” on page 12.
PeDesignV6Eng.book Page 10 Thursday, July 8, 2004 11:59 AM