Brother PE-DESIGN Ver.6 - Manual (Page 32)

24
Automatically Creating Embroidery Patterns
Step 7
Transferring the pattern to an
original card
Before you can actually sew the embroidery
pattern, you must transfer the pattern to a sewing
machine. Transfer the embroidery pattern to the
sewing machine using media of the type used by
your machine, for example, original cards, floppy
disks, CompactFlash cards, or USB media. For
this example, we will transfer the pattern to an
original card.
1.
Insert an original card into the USB card writer
module.
2. Click File on the menu bar, point to Write to
Card, and then click Current Design on the
submenu.
An alternate method is to click the Toolbar
button indicated below.
→ The following message appears.
3.
Click OK.
→ The following message appears.
b
Memo:
To quit the operation, click Cancel.
4.
Click OK to close the message.
Step 8
Quitting Layout & Editing
1.
Click File on the menu bar, and then click Exit.
→ The Layout & Editing window closes.
b
Memo:
Layout & Editing can also be closed by
clicking the close button on the right end of
the title bar.
a
Note:
The original card is inserted correctly when
you hear it snap into place.
a
Note:
If the original card is not brand new, make
sure that the patterns already stored on the
card are no longer needed.
Write to Card
a
Note:
If the card writer module is not correctly
connected or powered, or if the original card
is not inserted or is defective, an error
message will appear. For more details, refer
to “Writing an embroidery pattern to an
original card” on page 195.
PeDesignV6Eng.book Page 24 Thursday, July 8, 2004 11:59 AM