Operation – KROHNE MFC 400 EN User Manual
Page 73
OPERATION
6
73
MFC 400
www.krohne.com
08/2013 - 4002075802 - MA MFC 400 R02 en
C1.5.11
Proc: System Control
Selection of status signal (Failure, Out of Specification, Function Check,
Maintenance Required and Information) for the group "Proc: System
Control"
C1.5.12
Config: Totaliser
Selection of status signal (Failure, Out of Specification, Function Check,
Maintenance Required and Information) for the group "Config: Totaliser"
C1.5.13
Electr: Power Failure
Selection of status signal (Failure, Out of Specification, Function Check,
Maintenance Required and Information) for the group "Electr: Power
Failure"
C1.5.14
Electr: IO Connection
Selection of status signal (Failure, Out of Specification, Function Check,
Maintenance Required and Information) for the group "Electr: IO
Connection"
C1.6 Information
C1.6
Information
-
C1.6.1
Sensor Name
Name of measuring sensor
C1.6.2
Sensor ID
ID of measuring sensor
C1.6.3
Nominal Mass Flow
Nominal mass flow of measuring sensor
C1.6.4
Max. Allowed Temp.
Displays the maximum permitted temperature for the measuring sensor
C1.6.5
Min. Allowed Temp.
Displays the minimum permitted temperature for the measuring sensor
C1.6.6
Calibration Date
Date of factory calibration
C1.6.7
V No. Sensor
V number of the measuring sensor
C1.6.8
Serial No. Sensor
Serial number of the measuring sensor
C1.6.9
V No. Converter
V number of the signal converter
C1.6.10
Sensor Electronics
Displays the version of the measuring sensor electronics
C1.7 Flow Calibration
C1.7
Flow Calibration
-
C1.7.1...
1.7.25
CF1...CF27
Displays the measuring sensor calibration coefficients (not CF9 or CF10) for
the flow measurement
C1.8 Density Calib.
C1.8
Density Calib.
-
C1.8.1...
1.8.8
DCF1...DCF8
Displays the measuring sensor calibration coefficients for density
measurement
C1.9 Simulation
C1.9
Simulation
-
C1.9.1
Mass Flow
As in B1.1
C1.9.2
Volume Flow
As in B1.2
C1.9.3
Density
As in B1.3
C1.9.4
Temperature
As in B1.4
No.
Function
Settings / descriptions
.book Page 73 Monday, August 26, 2013 9:05 AM