KROHNE MFC 400 EN - Manual (Page 23)

ELECTRICAL CONNECTIONS
4
23
MFC 400
www.krohne.com 08/2013 - 4002075802 - MA MFC 400 R02 en
4.4.1 Connection of signal cable - Field housing and connection box for sensor
1 Unscrew the terminal compartment cover.
2 Pass the prepared signal cable through the cable entry.
3 Secure the signal cable using the clip.
4 Connect the electrical conductors as shown. The shielding must also be connected to the
spring terminal.
5 Re-fit the cover and tighten it by hand.
Figure 4-1: Connection of signal cable - Field housing and connection box for sensor
Cable Cable Connection terminal
Cable pair Colour
1 yellow X1 SA+
1 black X1 SA-
2 green X1 SB+
2 black X1 SB-
3 blue X2 T1
3 black X2 T2
4 red X2 T3
4 black X2 T4
5 white X3 DR+
5 black X3 DR-
INFORMATION!
Each time a housing cover is opened, the thread should be cleaned and greased. Use only resin-
free and acid-free grease.
Ensure that the housing gasket is properly fitted, clean and undamaged.
.book Page 23 Monday, August 26, 2013 9:05 AM