KROHNE MFC 400 EN - Manual (Page 110)

6
OPERATION
110
MFC 400
www.krohne.com 08/2013 - 4002075802 - MA MFC 400 R02 en
S S Proc: Signal
Low
Sensor signal low The sensor signals do not
reach the expected
amplitude. This can
influence the measuring
accuracy.
Check the product for
viscosity and gas bubbles.
S S Config:
Totaliser
Tot 1 FB4 Overflow Totaliser 1 FB4 has
overflowed and started
again at zero.
Check totaliser format.
Tot 2 FB5 Overflow Totaliser 2 FB5 has
overflowed and started
again at zero.
Tot 3 FB6 Overflow Totaliser 3 FB6 has
overflowed and started
again at zero.
Tot 1 Overflow Totaliser 1 has overflowed
and started again at zero.
Tot 2 Overflow Totaliser 2 has overflowed
and started again at zero.
Tot 3 Overflow Totaliser 3 has overflowed
and started again at zero.
I I Proc: System
Control
System Control Active System control is active.
I I Electr: Power
Failure
Tot 1 Power Failure Totaliser 1 invalid due to
power failure.
Check the value of the
totaliser.
Tot 2 Power Failure Totaliser 2 invalid due to
power failure.
Tot 3 Power Failure Totaliser 3 invalid due to
power failure.
Tot 1 FB4 Power Failure Totaliser 1 FB4 invalid due
to power failure.
Tot 2 FB5 Power Failure Totaliser 2 FB5 invalid due
to power failure.
Tot 3 FB6 Power Failure Totaliser 3 FB6 invalid due
to power failure.
Power Failure Detected Power failure has occurred.
The totaliser state may be
invalid.
.book Page 110 Monday, August 26, 2013 9:05 AM