beautypg.com

Q: a – In-Situ TROLL 9500 Operators Manual User Manual

Page 55

background image

48

TROLL 9500 Operator’s Manual

0095110 rev. 007 01/09

Depth

SETTING UP PRESSURE MEASUREMENTS: THE PA-
RAMETER WIZARD

Win-Situ’s Parameter Wizard can help you configure a pressure chan-
nel to display measurements just as you want them. The specified set-
tings are easily changed from one mode to another, and any choice
can be redone or undone later, when viewing test data.

1. With the MP TROLL connected to a host PC and selected in the

Navigation tree, select the pressure parameter.

2. Click or tap Edit.... The Parameter Wizard starts. The choices are

discussed below.

3. When you finish the Wizard, Win-Situ sends the information to the

device and updates the display.

PRESSURE SETUP CHOICES

Win-Situ prompts for the following when editing a pressure channel.
You may not see all of these depending on your early choices.

1. NAME (OPTIONAL)

The pressure channel name is displayed in the Information pane and
in test data files. A default name is proposed. If you choose, you may
enter a custom name (up to 16 characters).

2. DISPLAY MODE

Select one of the following. Subsequent screens will be tailored to
your choice.

s

sure exerted by the column of water
above the pressure sensor, in kiloPas-
cals or pounds per square inch (psi). If
you choose this mode, click Finish to end
the Wizard. Then select units on Win-
Situ’s Options menu.

s

column to a depth reading, in meters,
centimeters, feet, or inches. If you
choose this mode, you will be asked to
choose a method for converting pressure
to depth. Then select units on Win-Situ’s
Options menu.

s

surface water elevations. Data file read-
ings are “positive up.” Increasing water
levels will result in increasing readings.
Decreasing water levels correspond to
decreasing readings.

s

used for drawdown in ground water wells.
This mode is “positive down.” Decreas-
ing
water levels correspond to increasing
readings, because the water level is
getting further from the top of the well
casing. Increasing water levels result in
decreasing readings.

If you select depth or a level mode, you will be asked to choose a
method for converting pressure to depth or level. For a level mode,
you will be prompted to enter a level reference.

Q:

A:

What do I get with out-of-the-box pressure measure-
ments (no setup)?

The pressure channel defaults in Win-Situ and Pocket-Situ
result in the following measurements, with no setup:

s

Remember that all these settings can be changed quite
easily when you view the data after the test.

1

2

SECTION 7: MONITORING PRESSURE (WATER LEVEL)

This manual is related to the following products: