In-Situ TROLL 9500 Operators Manual - Manual (Page 34)

27
0095110 rev. 007 01/09 TROLL 9500 Operator’s Manual
CHOOSING MEASUREMENT UNITS AND OTHER PREFERENCES
Preferences can be set at any time, and are saved with the site. A
connection to the instrument is not required.
User-selectable preferences include:
s
The following Settings Options are also available:
s
To display the Preferences window, do one of the following:
s
s
a. Tap the Home site in the Navi-
gation tree...
b. then tap Setup... in the com-
mand bar.
Units
Default units are used for the display of data unless you specify other
preferences. To set unit preferences, first display the Preferences
window as above.
1. Select the Units tab.
2. In the top of the Units window, select a parameter whose unit you
wish to change.
3. In the bottom of the window, select the unit you want for the high-
lighted measurement. Repeat for as many units as you like.
4. Do one of the following:
s
Other Preferences
To change other aspects of Win-Situ/Pocket-Situ operation, first
display the Preferences window as above.
1. Click the Settings tab.
2. Select the options you want:
s
next session.
s Expand Devices on Find. This will take effect the next time you
click “Find.” The software will automatically display all nodes in
the device tree without any further action from you.
s
but you may select any rate from 2 to 60 seconds.
s
have selected “Don’t ask me this again” in any WIn-Situ or
Pocket-Situ dialog boxes.
Boxcar filtering is no longer available.
3. Select OK to close the window and apply the settings.
TIP: Preferences are saved with the site (on the PC), not in
the device.
SECTION 4: CONTROL SOFTWARE
a
b
2
3
1
1
2
3