GW Instek GDS-2000 series Uer manual - Manual (Page 165)

APPENDIX
165
GPIB Module Installation
For GPIB interface and remote control details, see page149.
GPIB kit contents  GPIB module
 Programming manual (programming manual is
also downloadable from GWInstek website).
Step 1. Turn Off the GDS-2000 power
switch.
2. Take off two screws and remove the rear panel
GPIB module cover.
3. Insert the GPIB module and put the screws
back.
4. Turn On GDS-2000. Press the
Utility key, then F2 (Interface)
repeatedly. Make sure GPIB
menu is selectable, and a GPIB
icon appears on the top left
corner of the display.
Utility
Interface
Menu
F 2