GW Instek GDS-2000 series Uer manual - Manual (Page 159)

MAINTENANCE
159
8. The calibration for Channel1
starts and ends
automatically, in less than 5
minutes.
Ch1 calibration 1/3
9. When finished, connect the
calibration signal to
Channel2 and press F5.
Channel2 calibration starts.
Done!!
10. (for 4 Channel model only) Repeat the above
step for Channel 3 and 4.
11. When the calibration for all channels is
completed, the display goes back the default
state.
Probe Compensation
Panel operation 1. Connect the probe between Channel1 input and
the probe compensation output (2Vp-p, 1kHz
square wave) on the front panel. Set the probe
attenuation to x10.
Utility
Help
CH1 CH2 MATH CH3 CH4
CH1
MENU
HORI MENU
CH2 CH3 CH4
CAT 300V M  16pF
MAX. 300Vpk
1 CAT 300V M  16pF
MAX. 300Vpk
1 2V
POSITION
HORIZONTAL
TIME/DIV
LEVEL TRIGGER VARIABLE
STBY ON/
POSITION POSITION POSITION
VERTICAL
POSITION
GDS-2104 Digital Storage Oscilloscope
100MHz 1G Sa/s
VOLTS/DIV VOLTS/DIV VOLTS/DIV VOLTS/DIV
2V
X10 X1
CH1 x1 x10
2. Press the Utility key.
Utility