Spectra Precision Survey Pro v4.5 Ranger User Manual - Manual (Page 37)

Getting Started
27
8. The colors of the objects in vector basemaps
can be modified by selecting the basemap
and then tapping Edit… to open the Edit
Basemap screen.
The Settings Screen
The Settings screen is used to control all of the settings available for
your total station, data collector, current job, and Survey Pro
software.
Most of the settings remain unchanged unless you deliberately
change them, meaning the default settings are whatever they were
set to last. For example, if you create a new job where you change the
direction units from azimuths to bearings and then create another
new job, the default direction units for the new job will be bearings.
Survey Pro behaves in this way since most people use the same
settings for a majority of their jobs. This way, once the settings are
set, they become the default settings for all new jobs and current jobs.
Some settings are considered critical and are therefore stored within
the job. The following settings are stored within a job and will
override the corresponding settings in the Settings screen when it is
opened:
• Scale
Factor
– Surveying Settings Card
• Earth Curvature On or Off – Surveying Settings Card
• Units for Survey Data (distances) – Units Settings Card
• North or South Azimuth – Units Settings Card
• Angle
Units
– Units Settings Card