Spectra Precision Survey Pro v4.5 Ranger User Manual - Manual (Page 113)

DTM Stakeout
103
Stake the DTM
13. With the information correctly entered in the Stake DTM screen,
tap Next > to continue.
14. The second Stake DTM screen will open
with a graphic that shows the reference
DTM, the centerline, if used, and any break
lines. Tap the Take Shot… button to take a
shot.
15. If a shot is taken when the prism is located
within the boundaries of the reference DTM
and within the polyline boundary (if
selected earlier), the graphic will change
and the Data, Result , and Centerline (if one
was selected) cards will be filled in. The
graphic will show the current triangle in the reference DTM
surface where the rod is located and a centerline and offset, if
selected earlier.
16. At anytime, you can view the current (non-reference) DTM
surface computed from the points staked so far by tapping the
3D View… button.
The Store button will store the last point shot.
The Result card displays additional information about the
last stake point and the Centerline card displays information
related to the last stake point in relation to the centerline, if
selected earlier.