Spectra Precision Survey Pro v4.5 Ranger User Manual - Manual (Page 245)

GPS Module
235
Receiver Settings – General
The controls on the Receiver Settings – General card will vary
depending on brand and model. Please see the documentation that
came with your GPS receiver for details on the different settings that
may be available. If using a Bluetooth GPS receiver, refer to the
Bluetooth section on Page 294.
RTK Settings
If you are using Survey Pro for RTK, or RTK simultaneous with post
processing data collection, the following cards of the Job > Settings
screen are used:
Measure Mode: is where you select the receiver dynamic for point
occupations and the type of GPS raw data to store for each point. You
can also set measurement acceptance criteria. These settings are
described in detail in the Reference Manual.
Post Processing Settings
If you are using Survey Pro for RTK simultaneous with post
processing, or post processing data collection, the Post Process card of
the Job > Settings screen applies.
Post Process: is where you turn on post processing data collection by
specifying a Recording Interval for the receiver’s internal memory. You
can also specify how to deal with autonomous positions and select a
special layer to store autonomous points on. These settings are
described in detail in the Reference Manual.
Start GPS Survey
The Start GPS Survey wizard is used to start any RTK survey. This
wizard will guide you through the steps required to choose a
coordinate system, set up your equipment, solve an adjustment, and
start collecting data or staking out points. The Start GPS Survey
wizard can be used for any RTK setup, regardless of your coordinate