Spectra Precision Survey Pro v4.5 Ranger User Manual - Manual (Page 325)

Basic GPS Module
315
the base but the projection is not fully set and solved for this
survey. The button will say Finish if you have set the base
and the projection is solved.
a. On Next >:
i. If the base was not set with this wizard, takes
you to Setup Remote Base screen (Page 316).
ii. If the base was set with this wizard, writes
the base and rover setup raw data, and takes
you to Solve Projection routine (Page 317).
b. On Finish: Writes the base and rover setup raw data,
sets the rover receiver and exits.
Start Survey – Connect to Rover
(Remote Base or Internet Base)
There are two workflows when you start a survey connecting to the
rover:
• The base broadcasting on a radio is already set and you wish
to start the rover with the remote base. This is the case
where there is more than one rover on a job site, or when you
exit and restart a job and you wish to restart the survey
without traveling back to the base.
• You are using the Internet to get corrections.
The workflow below is described for the NTRIP case. The remote
base on a radio is similar to the Set Rover and Setup Remote Base
procedure described above.
Connect to Internet
When Internet RTK is selected in the Job > Settings > Radio Settings
screen, we will always attempt to connect to the rover on the start of
the Start Survey Wizard. After connecting to the rover, we will dial
the Internet and attempt to decode the network type.
After the network type has been decoded, if it is a single base network
without an NTRIP logon protocol, we will go straight to Rover setup,
if it is a NTRIP network, we will go to the NTRIP Services page.