Spectra Precision Survey Pro v4.5 Ranger User Manual - Manual (Page 276)

User’s Manual – GPS Mode
266
6. In each case, the receiver will be put into static mode and the post
processing event will be logged to the data file ( when the
Measure Mode settings are Static on occupy and + Rx Raw) and a
site occupation begins.
7. The Occupy Data Point screen (or Check Control Point screen) is
updated with the local coordinate calculated from the
measurement. When you are satisfied with the measurement tap
Accept to return to the Data Collection screen
8. Check the Results tab for details on the last measurement. Check
the Map tab to see the points plotted as they are stored.
Topo SS
Use this method if you want to store a point at the current rover
position. When you tap Topo SS, Survey Pro will check the current
position against the measurement criteria. If the position is good,
then Survey Pro will store the point. You may be prompted for
description, layer, and/or attributes depending on your settings.
Offset Point
Use this method if you cannot occupy a point directly, but you can
occupy a location close by and provide an azimuth and distance to the
point.
1. Go to the Survey > Data Collection screen.
2. Tap Offset to open the Offset Shots screen.
Note: You can enter the offset data before or after you occupy the
reference point with GPS.
3. Tap Occupy GPS to occupy the GPS reference point. You will be
prompted for a point name to store the reference point. The
receiver dynamics are set and a site occupation begins. When you
are happy with the measurement, tap Accept to return to the
Offset Shots screen.