Spectra Precision Survey Pro v4.5 Ranger User Manual - Manual (Page 290)

User’s Manual – GPS Mode
280
Starting a New Job: One Point Localization
Scenario
You show up at a new job site where no previous coordinates exist.
You want to use RTK to create a new ground level coordinate system
for a legal and topo survey.
Objectives
This tutorial job will teach you:
¾ How to start a new job with one point and begin measuring ground
level distances without any existing control.
¾ How to set the base and rover receivers
¾ How to collect data points
¾ How to check to existing points.
Procedure
1. Create a new job.
• Enter Point Name 2 as the starting point and enter a starting
location of (5000, 5000, 100).
2. Set the base and rover.
• Go to Start GPS Survey, choose
Start Survey with One Point Setup>.
• Choose Set New Base and ‘connect’ to the Demo Mode
receiver. A simulated autonomous base position is received,
and you can Set the base.
• Connect to the Demo Mode rover, Set the Rover.
• You are now ready to collect data in your new coordinate
system.
3. Data collect points 3,4,54, and CHAP.
4. Move the base receiver to a different setup.
• Go to Start GPS Survey, choose Set New Base.