Spectra Precision Survey Pro v4.5 Ranger User Manual - Manual (Page 335)

Basic GPS Module
325
Connect to Base and Rover –
TDS Localization ‘One Point
Setup’
The Start Survey Wizard will have different behavior any time the
user is in Ground TDS Localization mode, and there is only one point
in the job. This behavior will be similar to the workflow to perform
the One Point Setup procedure that is currently supported in regular
GPS mode and is described below:
Setup Base Hardware Screen
This step is the same as the regular Basic Start Survey Setup Base
Hardware screen (Page 313).
1. Enter the antenna height.
2. On Next >, the base is setup to broadcast CMR+ corrections
over the radio port. The wizard advances to the Setup Rover
screen, below.
Setup Rover Screen
This screen is the same as the regular Basic Start Survey Rover
Setup screen (Page 314). In this case, the button at the bottom right
will always be Finish.
1. Enter the correct HR.
2. On Finish, writes the base and rover setup raw data; solves a
one-point localization; and the wizard exits to data collection.