Spectra Precision Survey Pro v4.5 Ranger User Manual - Manual (Page 246)

User’s Manual – GPS Mode
236
system requirements, and your base and rover equipment
configuration.
The steps required to complete the Start GPS Survey wizard will
depend on the coordinate system and equipment you are using. All
the possible steps are described below.
Start GPS Survey – Choose One
Point Setup
One point setup is a special case of the Start
GPS Survey wizard. You can use one point
setup mode only when you have a brand new
job with only one point. When you use one
point setup, Survey Pro will use Ground - TDS
Localization
mode, and automatically solve the
localization adjustment to give you ground
level coordinate system with the origin at your
first point. When you choose one point setup,
there are no additional steps required to solve
your coordinate system, all you have to do is
complete base and rover equipment setup and
you are ready to survey.
Start GPS Survey - Choose
Projection Mode
The Start GPS Survey Choose Projection mode screen is used to
choose the horizontal projection mode. There are two choices: