beautypg.com

One point localizations explained – Spectra Precision Survey Pro v4.5 Ranger User Manual User Manual

Page 267

background image

GPS Module

257

attached to each point record generated by GPS. Setup groups are

assigned as follows:
• When you set a new base point with an autonomous GET, Survey

Pro creates a new set up group for this point.

• When you collect geodetic measurements, each new point is

assigned the set up group of the current base station.

• When you set the base on an existing point with geodetic

coordinates, the point’s existing set up group is used as the new

base station set up group.

• When you set the base on a point with existing plane coordinates

and compute geodetic coordinates using the ‘Move Base’

algorithm, the existing coordinate system’s set up group is used
as the new base station set up group.

One Point Localizations Explained

When you want to open a new job and start a ground level survey

with no existing coordinates or control, you should use the Start GPS
Survey wizard one point setup option. After you set your base and

rover, you will be ready to collect data in a coordinate system with the

following properties:
• The coordinate system is scaled to ground level. Distances

measured with an EDM will be 1:1 with GPS measured
coordinates. Ground level is set automatically at the base

reference position. If your base is set at a height considerably

higher or lower than your survey area, use the Localization Set
Zone screen (Page 214).

• The coordinate system is oriented with grid north equivalent to

geodetic north at the base point. This means if you did a sun shot

at the base reference position; your solar azimuth would be

equivalent to grid azimuth along this meridian. If you did a sun
shot east or west of the base position, the solar azimuth would

differ from grid azimuth by meridian convergence.

• The coordinate system has its origin at the local northing and

easting of the first base position. The localization Translation
values would be the offset between the default map projection’s
origin (100000, 100000)m and the local coordinate of the base.