Spectra Precision Survey Pro v4.5 Ranger User Manual - Manual (Page 294)

User’s Manual – GPS Mode
284
screen opens and the session on this point is timed. Tap
Topo SS when you have occupied the point for the desired
length of time. This is the most precise way to collect a data
point.
7. Collect an additional observation to a point in the post processing
log file.
• Tap Post Process to open the RTK Rover Session screen. The
point name of the last point collected is the default name in
the Site ID field.
• Set the Duration to 1 minute and tap Start. When the session
is over, you will hear a beep. You can close the Receiver
Session screen.
8. Collect some quick points.
• Enter a new point range, say 301, and tap Topo SS. This is
the quickest way to store a point, although the measurement
is slightly less precise than if you occupy the data point.
9. Collect some feature points.
• Tap Feature to open the Feature Collection screen. Using a
Time Interval
of 5 seconds, tap Start to open the Occupy Data
Point screen.
• Tap Start to begin continuous collection, you will be prompted
for a description, feature, and attribute (depending on your
Survey settings) for this first point. All additional points will
be stored with these properties.
• Store a few points, then tap Done
• Tap Feature again, this time choose the Manual: prompt every
point
method. Tap Start to open the Occupy Data Point screen.
• Tap Topo SS to store each point, you will be prompted for the
properties of each point stored.
10. Move the base to a point in the coordinate file measured with
GPS.
• Close the Data Collection screen, and tap Start GPS Survey.