Spectra Precision Survey Pro v4.5 Ranger User Manual - Manual (Page 296)

User’s Manual – GPS Mode
286
Reuse Localization Solutions
Scenario
You want to return to the project site from the previous tutorial to
add some new measurements. You want to use a new job file for this
new work, but you want to reuse the coordinate system you have
already solved without the need to occupy the control points again.
Objectives
This tutorial job will teach you:
¾ How to export a job file of selected points.
¾ How to reuse a localization solution from a control file.
¾ How to solve a fixed scale horizontal adjustment.
¾ How to save and select a localization solution to the coordinate
system database.
¾ How to use the Adjust with Projection wizard when updating the
coordinate system site.
Procedure
1. With the job from the previous tutorial open, create a new job to
use for a control file on this site.
• Go to File > Export and select .JOB as the file type to export
and tap Next>.
• Tap To/From and enter points 1-4,52,54,chap,new. Tap Export
and save the file.
2. Open a new job with the control file created.
• Go to File > Open/New. Create a new job, selecting the file
you just exported as the control file.
• At the prompt to set the coordinate system, tap Yes. The
localization solution solved in the previous tutorial is set for
this job.
3. Assuming your base is set up, you can go directly to rover setup.
• Open the Start GPS Survey wizard and select
Use Remote Base>. Tap Set Rover>.