Spectra Precision Survey Pro v4.5 Ranger Reference Manual User Manual
Page 56
Survey Pro Reference Manual
R-48
Note: If the specified offset extends beyond the end of the road
profile, the cut/fill value is always computed from the design
elevation of the node you are staking to.
; Write Cut Sheet Data Only (No Store Point)
: When checked, as-
built points are not stored to the JOB file when staking points; only
the raw data is written to the RAW file.
; View from Gun to Rod (non-remote)
: When checked, the move
left or right information will be presented from the rod person’s point
of view. When unchecked it will be presented from the total station’s
point of view. (This option only applies when a robotic total station is
selected in the Instrument Settings.)
; View from Rod to Gun (remote)
: When checked, the move left or
right information will be presented from the rod person’s point of
view. When unchecked it will be presented from the total station’s
point of view. (This option only applies when a non-robot total station
is selected in the Instrument Settings.)
; Prompt for Layer
: When checked, a prompt to select a layer will
appear before any new point is stored from only the routines under
the Stakeout menu.
: When checked, a prompt to select feature
information will appear before any new point is stored from only the
routines under the Stakeout menu. This also requires that a feature
file be selected from the Files Settings card, described earlier.
Note: There is no Prompt for Description checkbox as in the Surveying
Settings card because you are always prompted for a description
when storing a point from a stakeout routine.
Use Perfect Stationing: When checked, staking locations will be
computed at perfect stationing intervals. For example, if your
starting station was 0+15 and your station interval was 100, your
next stakeout location will occur at 1+00 instead of 1+15.
Point Tolerance: this setting affects the Remote Staking routine
(Page R-279). When performing Remote Stakeout, the final graphic