Spectra Precision Survey Pro v4.5 Ranger Reference Manual - Manual (Page 290)

Survey Pro Reference Manual
R-282
Stake to Line
Stakeout Stake to Line .
.
The Stake to Line screen allows you to locate any location in relation
to a predefined line. The line can be defined by two points, a point
and direction, a polyline or the centerline of an alignment. Distance,
direction and cut/fill information is provided so the rod can locate the
line by traveling the shortest possible distance (a perpendicular offset
to the line).
Define Line / Polyline : When set to Define
Line (shown here), a line can be defined by two
points or a point and a direction. When set to
Polyline, (shown below) the line is defined by
an existing polyline or alignment.
Start Point: defines the first point of the line
to be staked.
Point / Direction : defines the second point
on the line, or the direction of the line to be
staked, respectively.
Begin Station: defines the station associated with the Start Point.
Tap Line… : displays a map of all the polylines
and alignments in the current job. Simply tap
the line that you want to stake to and then tap
.
To/From… : Opens the Point List screen (Page
R-443) where a point list can be created.
Backsight… : opens the Backsight Setup screen
(Page R-118).
Stake> : takes you to the second Stake Points
screen, described below.