Spectra Precision Survey Pro v4.5 Ranger Reference Manual - Manual (Page 208)

Survey Pro Reference Manual
R-200
Start Stop/Go
: use this setting if you want to start a log file in stop
and go mode, where the receiver will rove around. In stop and go
mode, the GPS raw data is continuously logged to the file to maintain
the initialization while roving around, this is the go part. Then,
static sessions are marked when the receiver is stationary over a
point, this is the stop part.
Recording Settings
: this area displays values from the Job | Settings
| Post Processing screen.
Change : opens the Job | Settings | Post Processing screen, where
you can modify the settings relevant to post processing data
collection.
Rec Interval
: displays the current recording interval for new logging
files.
Mem. Threshold
: displays the current minimum memory on disk
available before a warning is issued.
SV Threshold
: displays the current minimum number of satellites
tracked before a warning is issued.
HDOP Threshold
: displays the maximum HDOP allowed before a
warning is issued
Antenna
: displays antenna setup for this receiver. It will be in one of
two states:
• Last Antenna for this receiver: is displayed when you have not
yet set this receiver in Survey Pro. This value is the previous
antenna measurement you used with this receiver.
• Selected
Antenna
: is displayed when you have entered new
antenna measurements using the Receiver Antenna screen
(Page R-184)
Measured
: is where you enter the measured antenna height (for the
specified measure to mark).
Offset
: is the reduced offset (slant correction plus phase center offset)
for the currently selected antenna type and measure to mark.
Setup HR: opens the Receiver Antenna screen (Page R-184), where
you can change the antenna type, measure to mark, and offsets.