Spectra Precision Survey Pro v4.5 Ranger Reference Manual - Manual (Page 247)

Survey Menu – GPS Module
R-239
Adjust with Projection – Select Destination
Coordinate System
The Adjust with Projection Select Destination Coordinate System
screen is used to select the coordinate system to transform the job file
points into. The interface is identical to the Select Source Coordinate
System screen described above. This screen only shows when the
adjustment mode is set to Adjust From Source to Destination.
Adjust with Projection – Prompt Adjust
The Adjust with Projection Prompt Adjust screen is used to describe
the difference between the source and destination record, and to
prompt you whether or not you wish to adjust the job with the change
of projection. This screen only shows when the wizard is opened
because of a change of projection record.
Adjust job with new projection
:
is where you choose to adjust the job file points with the change of
coordinate system.
Adjust Horizontal and/or Vertical
: is where you choose how to update
the horizontal and vertical coordinates in the job. There are two
choices:
Prompt geodetic points only Prompt choose points