Spectra Precision Survey Pro v4.5 Ranger Reference Manual - Manual (Page 111)

Job Menu – GPS Module
R-103
IP Modem Settings Screen
The IP Modem Settings screen is used to create or modify an IP
modem configuration. (You can only configure in IP modem when
RTK Rover
is selected for the receiver.)
IP Address of Base
: is the IP address of the
base.
Port (Socket) of Base
: is the socket number of
the base.
Use Advanced Settings
: When checked, allows
you to specify alternate Hayes AT commands to
connect and disconnect. When unchecked, the
default connect command of ate0&d0dt and
disconnect command of ath0 will be used.
Connection Command
: is the alternate Hayes
AT command used to connect.
Disconnect Command
: is the alternate Hayes AT command used to
disconnect.
General Settings
The General Settings card is used to configure settings specific to
each brand and model. Models which have special settings available
are described below.
Settings For Trimble Receivers:
Store post process file to
: is where you choose the location of the
post processing file. Choices are:
• Receiver
memory
• Data
Collector
Note: This setting is only available when your receiver model is
5700, 5800, R7, R8.