Spectra Precision Survey Pro v4.5 Ranger Reference Manual - Manual (Page 192)

Survey Pro Reference Manual
R-184
Receiver Antenna
The Receiver Antenna screen is used to define
the parameters of the antenna used with the
current receiver. This screen may be opened
as the Base Receiver Antenna, Rover Receiver
Antenna, or the Post Processing Antenna
screen.
Antenna Type
: is where you select the model of
antenna to use. The options available here
depend on the current receiver.
Measure To
: is where you select method for
antenna height measurements. Most antennas
have only two choices, measure to bottom of mount, or a visible slant
measure mark.
Measured
: is where you enter the height of the antenna, measured to
the location specified in the Measure To field.
Radius
: is where you enter the distance from the antenna’s center to
the measuring mark on its outer edge.
Offset
: is where you enter the vertical distance measured from the
Measure To
location, to the phase center.
Serial#
: is the serial number of the antenna. This information is only
written as a note in the raw data.
Notch
: Is the notch number on the antenna that you are measuring
to.
Note: If your antenna type is Manual, the Radius and Notch fields
will not be available
Set : Updates the base antenna settings with the values selected on
this screen.