Spectra Precision Survey Pro v4.5 Ranger Reference Manual - Manual (Page 194)

Survey Pro Reference Manual
R-186
Base Setup Two – SET
This final Base Setup screen is used to SET the receiver as an RTK
base using the job file point as the reference position, and to configure
the base location in Survey Pro. This screen is shown when the base
point has measured or computed geodetic coordinates in the job.
Base Point
: displays the base point name
chosen in the previous screen.
Latitude
: displays the WGS84 latitude of the
job file point.
Longitude
: displays the WGS84 longitude of
the job file point.
Ellipse
Height: displays the WGS84 height of
the job file point.
< Back : returns to the previous Base Setup
screen.
SET : sets the receiver as an RTK base, and configures the base
reference position in Survey Pro. If there is a Recording Interval set
on the Job | Settings | Post Process page, a file will be opened and
logging of raw GPS measurements for post processing will start. The
base name and antenna measurement will be recorded in the file for
this static session.
Base Setup Two – GET and SET
This final Base Setup screen is used to GET an autonomous (HERE)
position from the receiver, SET the receiver as an RTK base, and
configure the base reference position in Survey Pro. This screen is
shown when the selected base point does not
have geodetic coordinates.
Base Point
: displays the base point name chosen
in the previous screen.
Latitude
: is where you enter the WGS84 latitude
for the base point.
Longitude
: is where you enter the WGS84
longitude for the base point.