Yokogawa 2-Wire Dual Channel Transmitter/Analyzer FLXA21 - Manual (Page 86)

<6. OPERATION OF SC (Conductivity)>
6-6
IM 12A01A02-01E 5th Edition : Oct. 31, 2013-00
In case of trouble, when you contact your nearest Yokogawa service center, please inform us
of the module and FLXA21 software revision displayed on the Detail screen and other display
information as well as the module productions number indicated on the nameplate attached to
the instrument.
Next
20
12
4
mA
15.00
New sensor?
“Yes” resets
sensor wellness data.
Yes
No
Reset wellness data
HOLD
FAIL
Next
c.c.(factory) 0.1000/cm
c.c.(adjusted) 0.1000/cm
Temp.comp.1 NaCl
Temp.comp.2 None
Polarization 1%
Sensor Ohm 500.0 Ω
USP
0.000%
Next
Sesor wellness:
Polarization
Cell constant
Heat cycle – – – –
Progress Time – – – –
Reset welness data
Next
2010/02/15 16:04:07
Last calibrated at
-------- ------
Calibration due at
-------- ------
Projected Calibration
-- (no meaning)
Next
SC module(sensor1):
Module Pdn No.
S12345
Software Revision 1.10
Next
HOUSING ASSY:
Module Pdn No. 23456789
Software Revision
2.10
HART Device Revision 2
Next
(Fig. 6.8)
*: This screen is displayed only if the PH201G distributor is used and “PH201G” is selected in communication setup.
*
Figure 6.6 Detail display
n Current output mA
= current output in mA. The range and function of this mA output can be set in Commissioning →
Output setup → mA.
For details, see section 7.2.