Yokogawa 2-Wire Dual Channel Transmitter/Analyzer FLXA21 - Manual (Page 41)

<2. WIRING AND INSTALLATION>
2-14
IM 12A01A02-01E 5th Edition : Oct. 31, 2013-00
2.6 Mounting methods
See Figure 2.9. The FLXA21 has various mounting possibilities.
• Panel mounting using optional mounting hardware (/PM or /UM)
• Wall mounting using optional mounting hardware (/U or /UM)
• Pipe mounting using optional mounting hardware (/U or /UM) on a horizontal or vertical
pipes (Nominal size: 50A)
The universal mounting kit (/UM) contains the pipe and wall mounting hardware (/U) and the
panel mounting hardware (/PM). Some can be left unused.
195
0
+1
138
0
+1
138
185
Unit: mm
Panel mounting
Wall mounting
Pipe mounting
Note: The attached hardware is the same
as that for the pipe mounting.
Only the bracket is used for the
wall mounting.
Note: Horizontal pipe mounting is
possible by turning the bracket
90 degrees.
M8 bolt (not supplied)
Prepare bolts of the same
length as the mounting hole.
Note: For a sun shade hood (option),
use the upper two bracket
mounting screws to fix it.
Bracket
Wall mounting holes (x3)
Wall
Bracket mounting screws*
Bracket mounting screws*
Fixing screws (x2)
Panel
Spacing panel cutout
Nuts (x2)
Washers (x2)
Stanchion (50A pipe)
Bracket mounting screws*
Bracket
Bracket
Bracket for piping
U-bolt
* Tighten the four screws to a torque of 2 N·m.
* Tighten the four screws to a torque of 2 N·m.
* Tighten the four screws to a torque of 2 N·m.
Figure 2.9 Three types of mounting with the optional mounting hardware
See General Specifications (GS 12A01A02-01E) for the dimensions of the FLXA21 and
mounting hardware.